ELICA EAS422SS Guía De Instalación, Uso Y Mantenimiento página 8

Venting outside through the wall
1 Measure from the bottom of the range hood liner to the
horizontal centerline of the vent opening (A).
B
A
C
D
5 Remove the vent duct from the range hood liner. Transfer
measurement A to the cabinet back wall. Measure from the un-
derside of the cabinet.
6 Mark the cutout as shown. Use a saber saw or keyhole saw
to cut a round opening through the back of the cabinet and the
exterior wall for the vent.
C
A
B
Non-vented (recirculating) installation through the soffit/
cabinet
A
G
B
D
F
I
E
H
A. Ceiling
B. Vent cover
C. Soffit
D. 6" (15.2 cm) vent
E. Range hood
8
A. Measurement A
B. Horizontal centerline of vent
opening
C. Range hood liner
D. 12" (30.5 cm) min. cabinet height
A. Measurement A
B. Centerline
C. 6¼" (15.9 cm)
round cutout
B
G
C
F
D
E
F. Cabinet
G. Wall
H. 12" (30.5 cm) min. cabinet
height
I. 17" (43.2 cm) min. vent cover
height
1 Measure and mark the centerline of the cabinet to the soffit
above.
2
Measure from the bottom of the cabinet to the centerline of
the where the vent will come through the soffit. Mark the loca-
tion and use a saber saw or keyhole saw to cut a 5¾" (14.6 cm)
hole for the vent cover.
A
*NOTE: For 12" (30.5 cm) high cabinets a 6¼" deep x 8" wide
(14.6 cm x 20.3 cm) rectangular opening in the cabinet top is
required for damper transition clearance.
3 Consider the cutout chart measures to make the openings
on the cabinet.
Complete preparation
1
If not yet attached, install the 6" (15.2 cm) vent transition
the top of the range hood liner using two 3.5 x 9.5 mm screws.
2 Locate side mounting bracket flush 1 cm to the bottom
of the cabinet side and against the inside of the front
cabinet face. Drill
a bracket using three 4.5 x 13 mm screws to each side of
the cabinet, and tighten.
Additional washers in hardware package are supplied as
spacers for cabinet walls thinner than ½"(13 mm).
A
A
A. 30" (76.2 cm) cabinet
B. Screws - 4.5 x 13 mm (8)
5 Install the vent system according to the method needed.
Use caulking to seal the exterior wall or roof opening.
B
1 ⁄ " (3 mm) pilot holes in 6 places, attach
8
B
C
D
C. Washers (optional)
D. Mounting bracket (2) (position for
30" [76.2 cm] cabinet)
Move the bracket ⁄ " (1 cm) from
6
1 6
the bottom side of the cabinet
A. Vent cover
B. Centerline