Tabla de contenido
Idiomas disponibles
Idiomas disponibles
WARNING:
Do not allow familiarity with products to make you care-
less. Remember that a careless fraction of a second is
sufficient to inflict serious injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1, along with hearing protection.
Failure to do so could result in objects being thrown into
your eyes resulting in possible serious injury.
WARNING:
Do not use any attachments or accessories not recom-
mended by the manufacturer of this product. The use of
attachments or accessories not recommended can result
in serious personal injury.
WARNING:
Verify that all guards and tubes are in place prior to use.
If the blower is dropped, stop blower and verify that
no damage has occurred. If any guard, part, or tube is
damaged or missing, do not use blower until it has been
repaired or replaced by an authorized service center.
Use of blower with damaged or missing guards, parts,
or tubes can result in serious personal injury or further
damage to the blower.
NOTICE:
Before each use, inspect the entire product for damaged,
missing, or loose parts such as screws, nuts, bolts, caps,
etc. Tighten securely all fasteners and caps and do not
operate this product until all missing or damaged parts
are replaced. Please contact customer service or a quali-
fied service center for assistance.
APPLICATIONS
You may use this product for the purposes listed below:
Clearing leaves and other debris from your lawn
Keeping decks and driveways free from grass clippings,
leaves, pine needles, and other debris
OPERATION
TO INSTALL / REMOVE BATTERY PACK
See Figure 3.
Always remove battery pack from your tool when you are
assembling parts, making adjustments, cleaning, or when
not in use. Removing battery pack will prevent accidental
starting that could cause serious personal injury.
To install:
Insert the battery pack into the product as shown.
Make sure the latches on each side of the battery pack
snap in place and that the battery pack is secured in the
blower before beginning operation.
NOTICE:
When placing battery pack in the tool, be sure raised rib
on battery pack aligns with the bottom of the tool and
latches into place properly. Improper installation of the
battery pack can cause damage to internal components.
To remove:
Locate the latches on the side of the battery pack and
depress both sides to release the battery pack from the
blower.
Battery tools are always in operating condition. Remove
battery pack when transporting or carrying blower to
avoid accidental starting, which may result in serious
injury.
For complete charging instructions, see the operator's
manuals for your battery pack and charger.
STARTING/STOPPING THE BLOWER
See Figure 4.
To start the blower, depress the switch trigger.
To stop the blower, release the switch trigger.
OPERATING THE BLOWER
See Figure 5.
To keep from scattering debris, blow around the outer
edges of a debris pile. Never blow directly into the center
of a pile.
To reduce sound levels, limit the number of pieces of
equipment used at any one time.
Use rakes and brooms to loosen debris before blowing.
In dusty conditions, slightly dampen surfaces when water
is available.
7 — English
WARNING:
WARNING:
Tabla de contenido
