Remote Control - Beamz Helene Double Laser RG Manual De Instrucciones

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

OPERATION
Access the three different operating modes available in this fixture by using the "MODE" button on the front panel. Press
"MODE" to cycle through the modes. Please see a description of each mode below.
1. Auto run and Sound active auto switching
The LED indicator on the front of the fixture will be orange (or orange flashing). Auto run will activate by no sound.
2. Sound active
The LED indicator on the front of the fixture will be green when the Sound active mode is selected.
3. Auto run
The LED indicator on the front of the fixture will be red when the Auto run mode is selected.
4. Power Off
The LED indicator on the front of the fixture will be off.

REMOTE CONTROL

1. Sound active mode
2. Select the autorun mode or the auto run and sound active auto
switching mode
3. Power ON /OFF
4. Select the laser colour in forward order
5. Select the laser colour in reverse order
6. Turn the LED ON/OFF or select the led colour in forward order
7. Turn the LED ON/OFF or select the led colour in reverse order
8. Reduce the sensitivity of the microphone
9. Increase the sensitivity of the microphone
10. Program buttons:
1. Autorun, constant rotation slow or flash.
2. Autorun, shake.
3. Autorun, stepping rotation back and forth.
4. Autorun and Sound active auto switching, same to 1.
5. Autorun and Sound active auto switching, same to 2.
6. Autorun and Sound active auto switching, same to 3.
The Wireless remote will immediately override the "MODE" button. No additional settings are required.
FIXTURE CLEANING
The cleaning of internal and external optical lenses and/or mirrors must be carried out periodically to optimize light output.
Cleaning frequency depends on the environment in which the fixture operates: damp, smoky or particularly dirty surrounding
can cause greater accumulation of dirt on the unit's optics.
Make sure the area below the installation place is free from unwanted persons during servicing
Housings, fixations and installations spots( ceiling, truss, suspensions) should be totally free from any deformation
The mains cables must be in impeccable condition and should be replaced immediately when even a small problem is
detected
In order to protect the fixture from overheat the cooling fans (if any) and ventilation openings should be cleaned
monthly.
The interior of the fixture should be cleaned annually using a vacuum cleaner or air-jet.
Clean with soft cloth using normal glass cleaning fluid.
Always dry the parts carefully.
Clean the external optics at least every month. Clean the internal optics at least every 30/60 days.
ATTENTION: We strongly recommend internal cleaning to be carried out by qualified worker!
7
Tabla de contenido
loading

Este manual también es adecuado para:

152.666

Tabla de contenido