Dmx-512 Connection; Remote Control; Replacing The Fuse - Beamz PartyBar 3 Manual De Instrucciones

DISPLAY

DMX-512 CONNECTION

If you are using a standard DMX controller, you can connect the DMX output of the controller directly to the DMX input of the
first unit in a DMX chain. Always connect the output of one unit with the input of the next unit until all units are connected.
5-pin XLR DMX Connectors.
Some manufactures use 5-pin DMX-512 data cables for DATA transmission in place of 3-pin. 5-pin DMX fixtures may be
implemented in a 3-pin DMX line. When inserting standard 5-pin data cables in to a 3-pin line a cable adaptor must be used.
The chart below details a proper cable conversion.
3-Pin XLR to 5-Pin XLR Conversion
Conductor
Ground/Shield
Data Compliment (- signal)
Data True (+ signal)
Not Used
Not Used
At the last fixture, the DMX cable has to be terminated. Solder a 120 Ohm resistor between signal (-) and signal (+) into a 3-pin
XLR connector and plug this into the DMX output of the last fixture in the chain.

REMOTE CONTROL

With the IR remote, you can operate the Par bar easy and you have many functions.
To control the fixture you must aim the remote at the front of the fixture and be no more than 30 feet
away.
A1: Full on
A2: Automatic colour change (jump effect)
A3: Automatic colour change (fade effect)
A4: Sound-activated mode
A5: Strobe effect
Colour: Select your colour with "+"or "-"
Speed: Select your speed with "+"or "-"
DMX: Select your DMX address with "+"or "-"
IP: Running effect

REPLACING THE FUSE

If the fuse is defective, replace the fuse with a fuse of the same type and value. Before replacing the fuse, unplug mains lead.
Procedure:
4
The control board offer several features: you can simple set the starting address,
run the pre-programmed program or make a reset. The main menu is accessed
by pressing the Mode-button, browse through the submenu by pressing Up or
Down.
Press the Enter-button in order to select the desired menu.
You can change the selection by pressing Up or Down. Confirm every selection
by pressing the Enter-button.
You can leave every mode by pressing the Mode-button. The functions provided
are described later in this manual.
3-Pin XLR Female (Out)
Pin 1
Pin 2
Pin 3
Step 1: Open the fuse holder on the rear panel with a fitting screwdriver.
Step 2: Remove the old fuse from the fuse holder.
Step 3: Install the new fuse in the fuse holder.
Step 4: Replace the fuse holder in the housing.
5-Pin XLR Male (In)
Pin 1
Pin 2
Pin 3
Pin 4 – Do Not Use
Pin 5 – Do Not Use