Wireless Remote Control; Replacing The Fuse - Beamz S700-JB Manual De Instrucciones

LAYOUT
1. Smokemachine power on/off
2. Effect on/off
3. 220~240VAC input
4. Smoke liquid level

WIRELESS REMOTE CONTROL

The remote controller allows you to control the fogger. See the instructions below to set up your fogger to
operate with the remote control.
There are 4 buttons on the wireless remote transmitter.
Press the fog button (1,2,3 or 4), and the fog machine will output fog for as long as you hold down the button.
Note: The duration of continuous fog output is based on the capability of the fog machine.
CLEANING
After 40 operating hours, the smoke machine must be cleaned to avoid deposits in the machine, pump and heater.
Procedure:
1. Remove smoke fluid from the tank, fill "Beamz smoke machine cleaner fluid" (item no. 160.670) into empty tank.
2. Switch the power on and wait until smoke machine is warmed up.
3. Press on the button of remote control and pump the liquid through the machine.
4. Perform the above operation until the tank is empty.
5. Fill the tank with Beamz smoke fluid.

REPLACING THE FUSE

If the fuse is defective, replace the fuse with a fuse of the same type and value. Before replacing the fuse, unplug mains lead.
Procedure:
Step 1: Open the fuse holder on the rear panel with a fitting screwdriver.
Step 2: Remove the old fuse from the fuse holder.
Step 3: Install the new fuse in the fuse holder.
Step 4: Replace the fuse holder in the housing.
ACCESSORIES
High quality smoke fluid on water basis, specially designed for Beamz smoke machines guarantees a trouble-free use.
5 liter packaging, ref. no. 160.582
1 liter packaging, ref. no. 160.643
Flavor, adds a pleasant fragrance to the air. One bottle is sufficient for 5 liter smoke fluid.
coconut 160.650
mint 160.651
vanilla 160.652
Run clean procedure in a well-ventilated area!
tropical 160.653
strawberry 160.654
energizer 160.655