AquaPRO 40011-3 Manual Del Usuario página 5

For 41041-2/41051-2 installation
Fasten the bracket onto the switch with two screws.
1.
2. Attach the bracket and switch to the discharge pipe with clamp (included), being sure to keep the vertical switch
vertical. Notice: the bottom of the float ball must be (2 in. above) the inlet of the pump.
3. Tie the power cords of pump and vertical switch to the discharge pipe with cable tie (not included).
Electrical
WARNING:
Risk of electric shock. Can shock, burn or kill. When installing, operating, or servicing this pump,
follow safety instructions listed below.
1. DO NOT splice the electrical power cord.
2. DO NOT allow electrical cord plug to be submerged.
3. DO NOT use extension cords. They are a fire hazard and can reduce voltage sufficiently to prevent pumping and/or
damage motor.
4. DO NOT handle or service pump while it is connected to power supply.
5. DO NOT remove grounding prong from plug or modify plug to protect against electrical shock, the power cord is a
three-wire conductor and includes a 3-prong grounded plug. Plug pump into a 3-wire, grounded, grounding type
receptacle. Connect pump according to electrical codes that apply.
For automatic operation, plug or wire pump into an automatic float switch or pump controller. Pump will run continuously
when plugged directly into an electrical outlet. Connect or wire pump to an individual branch circuit with no other outlets
or equipment in the circuit.
Size fuses or circuit breakers according to chart below.
Fuse Data
MODEL
40011-3
41011-3
41021-3
41041-3/41041-2
41051-3/41051-2
HP Voltage
1/2 115
1/2 115
3/4 115
1/2 115
3/4 115
Individual Branch Circuit Required (Amps)
5
15
15
20
20
20