Start The Machine; Stop The Machine; Adjust The Trimmer Head Angle; Maintenance - GreenWorks G40PHA Manual Del Operario

WARNING
If the blade jams on an electrical cord or line, DO NOT
TOUCH THE BLADE! IT CAN BE LIVE AND
DANGEROUS. Do the steps below:
1. Hold the insulated rear handle or put the machine
down and away from you.
2. Disconnect the electrically service to the damaged
line or cord before you try to free the blade.
4.1

START THE MACHINE

Figure 5.
1. Pull the small safety lock button upward.
2. Press the safety lock button.
3. Press the trigger while you hold the safety lock
button.
4. Release the safety lock button.
WARNING
Hold the machine with two hands during operation.
4.2

STOP THE MACHINE

Figure 5.
1. Release the trigger to stop the machine.
4.3 ADJUST THE TRIMMER HEAD
ANGLE
Figure 6.
The trimmer head pivots 135° and can be locked into 7
positions within that range.
1. Pull the pivot button and move the head forward or
backward to your desired position.
2. Release the pivot button.
WARNING
The trimmer head should lock securely in place.
5

MAINTENANCE

CAUTION
Do not let brake fluids, gasoline, petroleum-based
materials touch the plastic parts. Chemicals can cause
damage to the plastic, and make the plastic
unserviceable.
CAUTION
Do not use strong solvents or detergents on the plastic
housing or components.
English
Remove the battery pack from the machine before
maintenance.
5.1

CLEAN THE MACHINE

Keep the machine and the motor free of leaves,
branches or excessive oil to prevent fire risks.
• Use a moist cloth with a mild detergent to clean the
machine.
• Clean all moisture with a soft dry cloth.
• Use a small brush to clean the air vents.
5.2

LUBRICATE THE BLADE

To increase the efficiency and life of the blades,
lubricate them carefully after each work session:
• Put the machine on a flat and smooth surface.
• Use a soft cloth to clean the blades and a brush to
remove more dirt.
• Use a light layer of oil to lubricate the blades along
the top edge of the blade.
We recommend to use the non-pollutant type oil.
6

STORE THE MACHINE

Clean the machine before storage.
1. Remove the battery pack.
2. Let the motor cool.
3. Check that there are no loose or damaged
components. If it is necessary, replace the damaged
components, tighten screws and bolts, or speak to a
person of an approved service center.
4. Store the machine in a cool and dry location.
5
WARNING
WARNING
NOTE
NOTE
EN