Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Removing/Assembling the
Freezer Drawer Handle
Removing the Handles
1
Loosen the set screws
lower side of the handle with a
wrench and remove the handle.
2
Loosen the mounting fasteners
connect to the freezer drawer and handle
1
using a
/
in. Allen wrench, and remove
4
the mounting fasteners.
Assembling the Handles
1
Assemble the mounting fasteners
both ends of the handle using a
wrench.
2
Place the handle on the door by fitting
the handle footprints over the mounting
fasteners and tightening the set screws
1
with a
/
in. Allen wrench.
8
Removing/Assembling the
Doors and Drawers
Removing the doors is always recommended
when it is necessary to move the refrigerator
through a narrow opening.
located on the
1
/
in. Allen
8
that
at
Removing the Left Refrigerator Door
1
/
in. Allen
4
1
WARNING
If your entrance door is too narrow for the
y
refrigerator to pass through, remove the
refrigerator doors and move the refrigerator
sideways through the doorway.
Use two or more people to remove and
y
install the refrigerator doors. Failure to do
so can result in back or other injury.
Disconnect the electrical supply to the
y
refrigerator before installing. Failure to do
so could result in serious injury or death.
Do not put hands, feet or other objects into
y
the air vents or bottom of the refrigerator.
You may be injured or receive an electrical
shock.
Be careful when handling the hinge and
y
stopper. It may result in injury.
Remove food and bins from the doors and
y
drawers before detaching.
The water supply is connected to the
upper right part of the rear surface of the
refrigerator. Remove the ring in the joint
area. Hold the water supply connection
and gently push the Collet to detach the
water supply line as shown in
NOTE
Detachment of the water supply line is
applicable only when detaching the left
refrigerator door.
INSTALLATION
13
and
.
Collet
Capítulos
Tabla de contenido
Solución de problemas
