Información importante (cont.)
Toda la información contenida en estas instrucciones está basada en la información
más reciente disponible al momento de su publicación. Kohler Co. se reserva el
derecho de modificar el diseño de los productos sin previo aviso, tal como se
especifica en la lista de precios.
Install Using the Undermounter Kit
Nut
Écrou
Tuerca
Rail/Rail/Riel
Bolt
Boulon
Perno
For non-rectangular sinks, proceed to the "Install Using a Wood Frame Support"
section.
Install Using the Undermounter Kit
Thread the bolts into the nuts two turns.
Slide the nuts into the slots in the rails.
Position the bolts through the rail slots where the corners of the sink will be
located.
Slide a hanger bracket onto the end of each rail.
Position the rail assemblies into the cabinet running front-to-back.
Measure the overall width of your sink. This distance represents the distance "A"
between the outside edges of the rails as shown in the illustration.
Position the hanger brackets according to distance "A" and mark the screw hole
locations onto the cabinet.
Drill 1/8" (3 mm) starter holes at each marked location.
Proceed to the "Install the Sink" section.
Kohler Co.
Hanger Bracket
Support d'ancrage
Soporte de suspensión
Rail
Rail
Riel
Bolt
Boulon
Perno
A
5
1110103-2-A
