ZF 286 Serie Manual Del Usuario página 9

Fig. 6.1
POS.
1 PTO cover
2 Oil pump
3 Output shaft
4 Strainer / Oil filter
5 Drain plugs
6 Rear half housing
7 Front half housing
8 Oil dipstick
9 Breather
The gearbox must be filled with oil and the oil level checked before use. (see MAINTENANCE
section)
Using the gearbox with insufficient oil could damage the gears.
Too much oil could cause leakages through the gaskets and breather and considerably increase the
running temperature.
Under normal conditions, the drive should be reversed when the engine is idling.
In emergencies, the drive can be reversed with the engine running at maximum speed.
Repeatedly reversing the drive with the engine running at maximum speed will considerably
shorten the life of the clutches
Make sure the engine and propeller are at a standstill before carrying out any kind of operation
on the gearbox.
Plus d'informations sur : www.dbmoteurs.fr
ZF 286 IV
DESCRIPTION
9
POS. DESCRIPTION
10 Oil cooler
11 Filler plug
12 Shift control linkage bracket
13 Control valve
14 Valve control lever
15 1/8 NPTF pressure connector
16 M14x1.5 plug
17 Oil Filter
18 Input shaft
GB
Table 1