Metabo HPT RH 650V Manual De Instrucciones página 9

The position to which the switch is slid
will alternate between modes.
Switch [1] position:
Fixes the wind temperature at 120 °F
(50 °C) and enables the wind power
to be adjusted.
Switch [2] position:
Enables the wind temperature to be
adjusted between 120 °F (50 °C) and
1,200 °F (650 °C), and enables the
wind power to be adjusted.
Switch
[0]
2. Adjusting the Temperature (Fig.1,
Fig. 2, Fig. 3)
The temperature can be adjusted between
120 °F (50 °C) and 1,200 °F (650 °C) when
the switch is at the [2] position.
The temperature will rise by 20 °F (10 °C)
each time the Increase Temperature
button is pressed (to a maximum of
1,200 °F (650 °C))
Press the button continuously to increase
the temperature in increments of 20 °F
(10 °C).
The temperature will decrease by 20 °F
(10 °C) each time the Decrease Temperature
button is pressed (to a minimum of 120 °F
(50 °C)).
The set temperature will be indicated on
the display
Temperature and Decrease Temperature
buttons are pressed, but this will return
to the hot wind temperature display after
a few seconds.
The temperature will be fixed at 120 °F
(50 °C) when the switch is at the [1]
position, and adjustment is not possible.
This is used to quickly cool material that
Switch
Switch
[1] [2]
Fig. 2
when the Increase
is heat-warping and to cool the nozzle
when it reaches high temperatures after
using the tool.
Increase wind
power button
Increase
Temperature
button
3. Wind Power Adjustment (Fig.1, Fig. 3)
The wind power can be adjusted in five
stages between 1 and 5. (0.25 m
Press the [+] button to increase wind
power, and the [-] button to decrease
wind power.
The tool can be used with it stood
pointing upward. (Fig. 4.)
CAUTION:
Make sure the tool is placed on a stable
surface so that it won't topple over
when used pointing upward.
4. Attaching the Nozzle (Fig. 5)
CAUTION:
The nozzle is extremely hot immediately
after use, so do not touch it.
NOTE
Make sure you do not drop the nozzle.
A falling down nozzle can set an object
on fire.
Replace the nozzle for a type that is suited to
the job in hand.
Insert the nozzle supplied firmly into the hot
wind release nozzle until it can go no further.
English
Display
Decrease
Temperature
button
Decrease wind
power button
Fig. 3
3
to 0.5 m
Fig. 4
3
)
9