Work Example - Metabo HPT RH 650V Manual De Instrucciones

English
CAUTION:
Before attaching or replacing a nozzle,
allow the unit to cool down completely
or use a suitable tool.
A hot nozzle can set a surface on fire.
Place down hot nozzles only on fire-
proof surfaces.
An incorrect or defective nozzle can lead
to heat accumulation and damage the
unit. Use only original nozzles according
to the table that are suitable for your
unit.
Hot wind release nozzle
Nozzle (Plane)
5. Temperature Settings
WARNING:
Do not use the tool in the vicinity of
volatile substances (thinner, gasoline,
etc.)
Do not bring the hot wind release nozzle
in close contact with your hands or face
during use.
The nozzle is extremely hot immediately
after use, so do not touch it.
Set the temperature in consideration of the
article to be heated.
Also, pay attention to the surrounding
material that will be heated at the same time.
First of all, apply the hot wind from a distance
while checking that there are no changes in
the article being heated, and then move it
closer until it reaches an appropriate
distance.
Heating inflammable substances
(paper, wood, plastic, etc.)
Set the switch to the [1] position and
apply the heat with the nozzle at least 4"
(10 cm) away from the article being
heated.
10
Fig. 5
Gently move the tip of the nozzle up,
down, left and right to apply the heat.
Applying heat constantly to one location
may result in malformation or the
outbreak of smoke.
Heating non-flammable substances
(metal, stone, concrete, etc.)
Set the switch to the [1] position, and if
there are no problems, move it to the [2]
position.
Apply the heat with the nozzle at least 2"
(5 cm) away from the article being
heated.
Holding the nozzle too close may result
in the tool overheating, leading to
malfunctions.

WORK EXAMPLE

CAUTION:
Parts of the nozzles supplied are sharp,
so use gloves when removing them
from the case and when attaching or
detaching them.
Select the nozzle in consideration of the
shape of the article being heated and the
area being heated.
1. Peeling off paint (Fig. 6)
Use nozzle (flat) or nozzle (round) to
soften the paint with the hot wind, and
then remove it with the scraper supplied.
Note that heating the paint too much
may result in it scorching and becoming
harder, making it difficult to scrape off.
Nozzle (Plane)
Scraper
Fig. 6