Powermate PRTT196E Manual Del Operador página 9

Assembly
(Continued)
• Save all instructions
B
Assembly Instructions
The tiller comes fully assembled except for a few parts.
The following instructions will help you complete the tiller
assembly.
INSTALL THE WHEELS (See Figure 2)
1. Remove the locking pins from the axle.
2. The tiller wheels are directional. For best performance
install the wheels with the tire thread facing the direction
as shown.
3. Slide the wheel hub onto the wheel axle.
4. Align the wheel hub hole with the hole in the axle and
insert the locking pin.
5. Rotate the locking pin ring to lock the pin in position.
INSTALL THE TINES
1. Check the orientation of the tine blade. The sharp
cutting edge should be facing the direction of tine
rotation for your tiller.
2. Install the tine assemblies on each tine axle. Secure
with M10x50mm bolts and lock nuts. Do not over tighten
the tine bolt. This could damage the tine assembly and
cause difficulty in removing the tine assembly from the
tine axle.
INSTALL THE TINE SHIELD
1. Remove the 4 bolts installed in the tine shield brackets
above the transmission housing.
2. Place the tine shield on the bracket and secure with the
bolts removed in 1. above.
3. Install the tine shield side with the hardware provided.
INSTALL THE DEPTH REGULATOR
1. Remove the bolt and knob from the depth regulator lever.
2. Insert the depth regulator into the bottom of the depth
regulator bracket.
3. Insert the pin thru the bracket and lever.
4. Install the bolt and knob removed in 1. onto the depth
regulator lever.
Questions? Call Toll Free at 1-800-737-2112
(See Figure 3)
If you need assistance or find any parts missing, CALL
TOLL FREE: 1-800-737-2112.
Copyright © 2012 MAT Engine Technologies, LLC
8
Pin
Depth Regulator Bracket
Depth Regulator Lever
Figure 3