GRE POOL EXPERT PLBH144 Manual De Instrucciones página 4

The method of fastening the housing to the pool wall varies depending on
whether it is a floodlamp for concrete pools or prefabricated pools.
Concrete swimming pool
Place the crosshead mount of the flat floodlamp in the designated place. Mark
the holes. Drill with a Ø8 bit and insert the 4 fastening blocks.
Position the crosshead mount so that the word "TOP" is located on the upper
part.
Use four 4.8x25 screws to secure the crosshead mount to the wall (Fig 2).
Place the conduit body in the upper left quadrant of the crosshead mount, in a
accordance with the measurements shown in Fig 3.
Prefabricated/Liner swimming pool
Place the crosshead mount of the flat floodlamp in the designated place. Mark
the holes. Drill with a Ø8 bit.
Position the crosshead mount so that the word "TOP" is located on the upper
part.
Use four M-6x35 screws with four washers to secure the crosshead mount to
the inner wall of the swimming pool. Place 4 butt joints between the mount and
the liner. On the outer side of the swimming pool, insert 4 washers and r
nuts(Fig 2).
Place the conduit body in the upper left quadrant of the crosshead mount, in
accordance with the measurements shown in Fig 3. Use the butt point and the
conduit nut to secure on the outer side of the swimming pool.
4. ASSEMBLY:
The floodlamp is supplied with 2.5m of cable. It should be inserted through the
conduit body (Fig 4), leaving approximately 1.5m of cable in order to be able to
remove the floodlamp to the border of the swimming pool if handing or lamp
change is required (Fig 1).
Wind the cable in counter-clockwise direction under the screen fastening
clamps(Fig 5). Firmly secure the gland seal nut (Fig 6).
In order to secure the floodlamp to the crosshead mount, ensure that the word
"TOP" is located on the upper part. First, insert the lower clamp of the screen in
the crosshead mount.
Then, press on the upper part until the floodlamp is firmly inserted in the
crosshead mount.
5. MAINTENANCE:
To remove the floodlamp to the edge of the swimming pool (Fig. 1) Insert a
screwdriver through the upper hole of the ornament and press on the spline of
the mount until the floodlamp is released.(Fig 7-8).
Pull up on the floodlamp until it is released from the lower groove and can be
removed from the seimming pool.
Unlock the screw, Dismount the floodlamp by turning the key in counter-
clockwise direction (Fig 9).
Pull on the lamp to separate it from the lamp holder. Connect the new lamp (Fig
10).
VERY IMPORTANT: To change the lamp, always use the cardboard protector
and never touch the new lamp with your bare hands.