General Characteristics - GRE POOL EXPERT PLBH144 Manual De Instrucciones

ENGLISH
IMPORTANT: The instruction manual you are holding includes essential
information on the safety measures to be implemented for installation
and start-up. Therefore, the installer as well as the user must read
the instructions before beginning installation and start-up.
Keep this manual for future reference.
To achieve optimum performance of the Standard Floodlamp follow the
instructions provided below:
1. VERIFY THE CONTENTS OF THE PACKING:
The following accessories are included inside the box:
Floodlamp unit
Crosshead mount
Bag of screws

2. GENERAL CHARACTERISTICS:

This floodlamp has been designed to be used fully submerged underwater in
fresh water swimming pools. It is a Class III electric apparatus with very low
safety voltage (12V with alternating current).
The floodlamp compiles with IPX8 degree of protection (resistance to
penetration of dust, solid bodies and humidity) at a nominal immersion depth
of 2 m.
This floodlamp compiles with international safety standards for lights,
especially the EN 60598-2-18 standard. LIGHTS PART 2: SPECIFIC
REQUIREMENTS SECTION 18 LIGHTS FOR SWIMMING POOLS AND
SIMILAR APPLICATIONS.
The manufacturer is not responsible in any circumstances for assembly,
installation or start-up of any electric components which have been inserted
or handied at locations other than its own premises.
3. INSTALLATION:
 Never install in vertical positlon with the lamp facing downwards,
 In order to clearly light a pool it is recommended lo install a 75W floodlamp
every 10 or 15 m² of water surface.
In swimming pools which are especially deep, a 75 W floodlamp is
required for every 12 or 16 m³ of water volume.
 In order to prevent glare, the floodlamps should be installed so that they face
away from the residence or usual view of the swimming pool.
 In the event that lighting is used in training or competition pools, the
floodlamps should be installed on the sides to prevent glare on the
swimmers.
 To avoid the need to empty the pool to change the lamp, we recommend
that the floodlamp be installed in areas which are accessible from the upper
edge of the pool.
Prior to installation verify that the gland seal has been fully tightened.
The floodlamp should be placed on the wall of the pool at approximately 700
mm from the water surface(Fig.1).