Automatic Shutoff; Operation - Beurer EM 38 Manual De Instrucciones

Extending the belt
If the belt is not adequate for your waistline, you can use the extension belt provided. Depending on your
waistline, the holder for the control unit may be away from the center of your body. It is important that the
belt is positioned so that the electrodes C are to the left and right of the spinal column.
Inserting the control unit
• Insert the control unit into the holder on the belt. If inserted correctly, the
control unit clicks into the holder.
• The control panel should be facing outwards and the display should be
facing upwards and towards you.

Automatic shutoff

If the unit is not used after being switched on, it switches off after 3 minutes.
Changing the batteries
If the battery status indicator [6] flashes, change the batteries. To
insert or replace batteries, remove the control unit from the holder
of the belt.
1. Release the magnetic connection by gently pulling the control unit
away from the belt. You can feel the magnetic connection of the two
contact buttons release.
2. Pull the unit upwards and out of the holder.
3. Open the battery compartment [4] by pushing the cover downwards
at the arrow.
4. Insert 3 AAA Alkaline Batteries. Ensure the correct polarity.
See the diagram inside the battery compartment.
NOTICE:
• Do not use rechargeable batteries.

8. Operation

General information about use
The back belt is intended for individual treatment of pain in the lower back area.
NOTICE:
• Do not switch on the unit until the belt is fitted correctly. See Section 5.
Switching on the unit
Press and hold down the on/off button [1] until the unit beeps and the LCD display [5] switches on.
When the unit is started for the first time, Program A is activated automatically.
Selecting the program
Press the program button P [3] to change programs. The following programs are available:
Program Frequency
A 4 Hz –110 Hz (3 phases)
B 4 Hz
C 2 Hz (burst)
D 100 Hz
Time
30 min.
25 min.
25 min.
25 min.
8