Controls & Settings - A SYSTEMS DMP808 Manual Del Usuario

DMP808 / DMP808D
CONTROLS & SETTINGS
FRONT PANEL
1. Mounting Holes
These holes are for mounting the DMP808 on a standard
19" rack.
2. Power Switch
Flick this switch to sturn the unit on or put it on standy. Be
aware that the power switch can be disabled through the
Asystems DMP808 software.
3. Power LED
This LED indicator will illuminate when the DMP808
is activated – whether by switch or through the remote
software.
4. Disable LED
This LED will light up when the power switch is disabled.
When this occurs, the DMP808 cannot be turned on or
put on standby via the front panel switch. This function is
disabled within the Asystems PC software.
5. Output LEDs
The Mix Output LEDs will light up green when an output
signal is present on the corresponding output mix. It will
also flash red when the output channel clips. In this event,
you can reduce any excessive input signals, or turn down
your master output mix level through the control software.
English
6. Signal/Clip LED
This LED indicator is found on every input channel. When
a signal is present in the input channel, the LED will light
up green. When it clips, it will light up red. In the event that
the LED is red, we suggest reducing the input signal level.
Occasional flashes may be acceptable if it doesn't affect
your program material.
7. Gain Controls
These rotary controls will allow users to adjust the final
input level for channels 1 through 8.
6 5 3
7 4
4
2 1