Fanimation KWARTET FPS8553 Serie Manual De Instrucciones página 11

How to Assemble Your Light Kit or Cap (Continued)
Option B--for use with light kit
4. Assemble the light kit to the support bracket using
the two key slots in the light kit. Replace the previously
removed screw and securely tighten all three screws.
(Figure 4)
5. Remove the three screws in the light kit and retain
the screws for later. (Figure 5)
6. Connect the 2 single pin connectors from the LED
assembly to the 2 single pin connectors from motor
assembly. (Figure 6)
CAUTION
To reduce the risk of electric shock, disconnect the
electrical supply circuit to the fan before installing
your light kit.
7. Assemble the LED assembly to the light kit using
the previously removed screws and secure all three
screws. (Figure 7)
CAUTION
The light source is designed for this specific
application and can overheat if serviced by untrained
personnel. If any servicing is required, the product
should be returned to an authorized service facility
for examination or repair.
8. Secure the glass to light kit by twisting in a
clockwise direction. Twist the glass gradually
snaps onto the light kit.
(Figure 8)
until it
Do not over-tighten.
Motor
Assembly
Light Kit
Light Kit
Light Kit
LED Assembly
Light Kit
Glass
11
Figure 4
Figure 5
LED
Assembly
Figure 6
Figure 7
Figure 8