Zenoah GZ360 Manual De Usuario página 27

maximum speed. It is also important that the saw chain
does not rotate at idle. If the L-jet is set too lean it may
cause problems when you start the product, as well as
poor acceleration. If the H-jet is set too lean the product
will have less power, poor acceleration and could suffer
damage to the engine.
Examination, maintenance and service
of the product's safety equipment
Note: All service and repair work on the product
demands special training, especially maintenance work
regarding the safety devices on the product. If your
product fails any of the checks described below we
recommend you to bring your product to your servicing
dealer.
To do a check of the brake band
1. Brush off any wood dust, resin and dirt from the
chain brake and clutch drum. Dirt and wear can
impair operation of the brake.
2. Do a check of the brake band. The brake band must
be at least 0,6 mm (0.024 inch) thick at its thinnest
point.
To do a check of the front hand guard
Regularly carry out a check of the front hand guard and
the inertia brake release.
1. Do a visible check to make sure the front hand guard
is not damaged and that there are no visible defects
such as cracks.
321 - 004 - 27.09.2017
2. Move the front hand guard forwards and backwards
to make sure it moves freely and that it is securely
anchored to the clutch cover.
3. Place the chainsaw, with the engine switched off, on
a stump or other stable surface.
4. Release the front handle and let the chainsaw fall by
its own weight, rotating around the rear handle
towards the stump.
5. Make sure that the chain brake activates as the
guide bar hits the stump.
To do a check of the brake trigger
1. Place the chainsaw on firm ground and start it. See
instructions under heading
page 15 .
WARNING: Make sure that the saw
chain does not touch the ground or any
other object.
To start the product on
27