3. S
ETUP
AC Power
Proper Usage
Page 10 of 44
The MiN Laser RG has an external auto-ranging power supply and it can work
with an input voltage range of 100 to 240 VAC, 50/60 Hz.
To determine the product's power requirements (circuit breaker, power outlet,
and wiring), use the current value listed on the label affixed to the product's
back panel, or refer to the
indicates the product's average current draw under normal conditions.
· Always connect the product to a protected circuit (circuit breaker or
fuse). Make sure the product has an appropriate electrical ground to
avoid the risk of electrocution or fire.
· To eliminate wear and improve its lifespan, during periods of non-use
completely disconnect from power via breaker or by unplugging it.
Never connect the product to a rheostat (variable resistor) or dimmer
circuit, even if the rheostat or dimmer channel serves only as a 0 to 100%
switch.
This product is for overhead mounting only. For safety purposes, Chauvet
recommends mounting lighting effect products on steady elevated platforms or
sturdy overhead supports using suitable hanging clamps. In all cases, use
safety cables. Obtain appropriate mounting hardware from your lighting vendor.
International laser safety regulations require that laser products must be
operated in the fashion illustrated below, with a minimum of 9.8 feet
(3 meters) of vertical separation between the floor and the lowest laser
light. Additionally, 9.8 feet (3 meters) of horizontal separation is required
between laser light and audience or other public spaces.
3 meters
CAUTION! USE OF CONTROLS, ADJUSTMENTS, OR PROCEDURES
OTHER THAN THOSE SPECIFIED IN THIS USER MANUAL MAY RESULT
IN HAZARDOUS RADIATION EXPOSURE.
Technical
Specifications. The listed current rating
3 meters
MiN Laser RG User Manual Rev. 2