Fitting The Back To The Chair - Jay Zip Back Manual De Instrucciones

E N G L I S H
DETERMINING COMPATIBILITY
Wheelchair Types
The Zip Back is designed to be compatible with most wheelchairs
with the following exceptions:
Wheelchairs that are angularly adjustable, recline or tilt and result
in a back angle greater than 60 degrees from the vertical should not
be used.
WARNING
Use with these types of wheelchairs may cause the
back to accidentally disconnect from the wheelchair
resulting in a fall and the potential for serious injury.
Wheelchair Dimensions
The JAY Zip back is designed to replace the wheelchair's sling
upholstery. Prior to installation determine if the wheelchair used
has compatible back canes, by measuring the width between your
back canes as seen in Figure 1. Then using that measurement,
check Table 1 to determine if the back will fit your chair.
Next check that the back canes are a compatible diameter. The Zip
back hardware can be mounted on wheelchair back canes that
measure in diameter 3/4" (with insert), 7/8" (with insert) or
1" (no insert). (Figure 2)
If you cannot determine that the back canes are compatible
please contact your authorized Sunrise Medical provider
or Sunrise Medical customer service.

FITTING THE BACK TO THE CHAIR

A
Zip Back Width*
Minimum width
(all contours)
8"
10"
12" 11.875
14" 13.875
* Back Width is identified in your back's part number.
Example: JZIPB10S is a 10" wide back.
Insert for 3/4" diameter
back canes
5
Figure 1
A
Width of back canes from outside to
outside of the tubes (Fig. 1-A)
Maximum width
inch cm inch
7.875 20.00 9.125
9.875 25.08 11.125
30.16 13.125
35.24 15.125
Figure 2
Insert for 7/8" diameter
back canes
Table 1
cm
23.18
28.26
33.34
38.42
120688 Rev. A