Lighting The Side Burner - Weber Summit E420 Guia Del Propietario

Ocultar thumbs Ver también para Summit E420:
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

18
MAIN BURNER MANUAL LIGHTING
Failure to open the lid while igniting the barbecue's burners,
or not waiting 5 minutes to allow the gas to clear if the
barbecue does not light, may result in an explosive flame-up
which can cause serious bodily injury or death.
1)
Open the lid.
2)
Make sure all burner control knobs are turned off. (Push each knob in and turn
clockwise to ensure they are in the "OFF" position.)
WARNING: The burner control knobs must be in the "OFF"
position before turning on the liquid propane cylinder valve.
If they are not in the "OFF" position, when you turn on the
LP cylinder valve, the "excess gas flow control" feature will
activate, limiting the flow of gas from the LP cylinder. If this
should occur, turn off the LP tank valve and burner control
knobs. Then start over.
When the "excess gas flow control" feature is activated,
a small amount of gas is still flowing to the burners. After
turning off the cylinder and burner control knobs, wait at
least 5 minutes for the gas to clear before attempting to light
the barbecue. Failure to do so may result in an explosive
flame-up, which can cause serious bodily injury or death.
3)
Turn the cylinder on by turning the cylinder valve counterclockwise.
4)
Put match in the match holder and strike match.
WARNING: Do not lean over open barbecue.
5)
Insert match holder and lit match down through cooking grates and Flavorizer
bars to ignite the selected burner.
6)
Push the control knob in and turn to "START/HI".
WARNING: If the burner does not light, turn the burner
control knob to "OFF" and wait 5 minutes to let the gas clear
before you try again.

LIGHTING THE SIDE BURNER

Failure to open the lid while igniting the side burner, or not
waiting 5 minutes to allow the gas to clear if the side burner
does not light, may result in an explosive flame-up which can
cause serious bodily injury or death.
WARNING: Check hose before each use of barbecue for nicks,
cracking, abrasions or cuts. If the hose is found to be damaged
in any way, do not use the barbecue. Replace using only Weber
authorized replacement hose. Contact the Customer Service
Representative in your area using the contact information on
our web site. Log onto www.weber.com
1)
Open the side burner lid.
2)
Check that the side burner valve is turned off (Push control knob in and turn
clockwise to ensure that it is in the "OFF" position), turn all burners not being used
to the "OFF" position (push in and turn clockwise).
OPERATING INSTRUCTIONS
DANGER
DANGER
DANGER
®
.
* The grill illustrated may have
slight differences than the
model purchased.
®
TO EXTINGUISH
Push in and turn each burner control knob clockwise to "OFF" position.Turn gas supply
off at the source.
WARNING: The burner control knobs must be in the OFF
position before turning on the liquid propane cylinder valve.
If they are not in the OFF position, when you turn on the
LP cylinder valve, the "excess gas flow control" feature will
activate, limiting the flow of gas from the LP cylinder. If this
should occur, turn OFF the LP tank valve and burner control
knobs. Start over.
When the "excess gas flow control" feature is activated,
a small amount of gas is still flowing to the burners. After
®
turning OFF the cylinder and burner control knobs, wait at
least 5 minutes for the gas to clear before attempting to light
the barbecue. Failure to do so may result in an explosive
flame-up, which can cause serious bodily injury or death.
5
6
DANGER
WWW.WEBER.COM
®
Tabla de contenido
loading

Este manual también es adecuado para:

Summit e450Summit s420Summit s45089964

Tabla de contenido