How To Install Your Canopy Housing; How To Install The Light Bulb - Fanimation The Sandella MAD3260 Serie Manual De Propietario

NOTE: This step is applicable after the necessary wiring
is completed.
▲WARNING
To avoid possible fire or shock, make sure that the
electrical wires are completely inside the canopy housing
and not pinched between the housing and the ceiling.
1. Remove one of the two shoulder screws in the
hanger bracket. Loosen the second shoulder screw
without fully removing it. Assemble canopy by
rotating key slot in canopy over shoulder screw in
hanger bracket. Tighten shoulder screw. Fully
assemble and tighten second shoulder screw that
was previously removed (Figure 16a).
2. Securely attach and tighten the canopy screw cover
over the shoulder screws in the hanger bracket utilizing
the keyslot twist-lock feature (Figure 16b).
1. Install included 35W minican bulbs into each of the
two sockets. (Figure 17)
CAUTION
To reduce the risk of fire, use 35-watt max. type
T4-minican JD E11 tungsten halogen bulb. Turn off
the wall switch and allow the bulb to cool for 10
minutes before relamping.
Bulb is pressurized and may shatter. DO NOT
TOUCH BULB WITH BARE HANDS. Fingerprints
may result in shorter bulb life. Remove fingerprints
with alcohol prior to use.

How to Install Your Canopy Housing

How to Install the Light Bulb In Uplight
Figure 16a
35W Minican
Light Bulb
9
Figure 16b
Figure 17