Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Attach the rubber ring, the nozzle and the holder cap.
Make sure holder cap is tightened firmly.
NOTICE:
Clean the holder with appropriate solvent after
•
every day's work.
material may cause tool breakage.
OPERATION
CAUTION:
Do not touch the rod during operation. Otherwise
•
your finger may be pinched between the rod and
the housing of the tool.
Always wear goggles during operation.
•
NOTICE:
Do not cover vents, or it may cause overheating
•
and damage to the tool.
If you can not pull out the rod, turn the speed
•
adjusting dial to 1, and pull the switch trigger for a
moment, and try to pull the rod out after the motor
stopped. If the rod is still clogged, perform the
same action until the rod is able to move.
Cut off the tip of the nozzle suitable for individual
operation. Be careful how much you cut the nozzle. The
diameter of the nozzle affects the amount of caulking
material dispensed.
Pull the trigger to dispense caulking material.
The amount of the caulking material dispensed is
determined by the trigger, the speed adjusting dial, the
diameter of the nozzle opening, caulking material type,
and temperature.
It is recommended that the speed adjusting dial is set to
'1' and pull the trigger slowly at the first time to test how
much amount of caulking material is dispensed.
When the rod reaches front end, the motor starts idling.
Replace the caulking material when it happens.
NOTE:
If the caulking material is not dispensed, check the
following items:
Nozzle tip is not cut adequately. Cut the nozzle tip
•
suitable for individual operation.
Hardened material gets clogged in the nozzle.
•
Remove the hardened material.
The cartridge is damaged. Replace the cartridge.
•
Caulking material is stiff. Warm the material until it
•
becomes soft.
The wrong piston is used. Use appropriate piston.
•
Otherwise adhered caulking
MAINTENANCE
CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before attempting to
perform inspection or maintenance except for the
following troubleshooting related to the light.
Never use gasoline, benzine, thinner, alcohol or
•
the like. Discoloration, deformation or cracks may
result.
Clean the holder and the rod after every day's
•
work. Keep them free from the adhesive material.
Remove the caulking material before it hardens.
Remained adhesive material may cause breakage
of the tool.
To maintain product SAFETY and RELIABILITY, repairs,
carbon brush inspection and replacement, any other
maintenance or adjustment should be performed by
Makita Authorized or Factory Service Centers, always
using Makita replacement parts.
OPTIONAL ACCESSORIES
CAUTION:
These
accessories
•
recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to
persons.
attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
Piston A
•
Piston B
•
Piston C
•
Short holder (300ml(18.3cu.in)) set
•
Long holder (600ml(36.6cu.in)) set
•
Nozzle
•
Safety goggles
•
Makita genuine battery and charger
•
NOTE:
Some items in the list may be included in the tool
•
package as standard accessories. They may differ
from country to country.
9
or
attachments
Only use
accessory or
are
Tabla de contenido
