Fanimation CELANO v2 FP8062B Serie Manual De Instrucciones página 13

CAUTION
To reduce the risk of electric shock, disconnect the
electrical supply circuit to the fan before installing
your light kit.
1. Remove one of the three screws in the support
bracket at the bottom of the motor assembly and retain
the screw for later. Slightly loosen the remaining two
screws. Assemble the light plate assembly to the
motor assembly support bracket using the two key slots
in the light plate assembly. Replace the previously
removed screw and securely tighten all three screws.
(Figure 1)
2. Remove one of the three screws in the light plate
assembly and retain the screw for later. Slightly
loosen the remaining two screws. Connect the 2 single
pin connectors from the LED assembly to the 2 single
pin connectors from motor assembly. (Figure 2 )
CAUTION
The light source is designed for this specific
application and can overheat if serviced by untrained
personnel. If any servicing is required, the product
should be returned to an authorized service facility
for examination or repair.
3. Assemble the LED assembly to the light plate
assembly using the two key slots and replace the
third screw and securely tighten all three screws.
(Figure 3 )
4. Secure the glass to the LED assembly by twisting
in a clockwise direction. Do not over-tighten. (Figure 4)
How to Assemble Your Light Kit
13
Light Plate Assembly
Figure 1
Light Plate
Assembly
LED Assembly
Figure 2
Light Plate
Assembly
Figure 3
Glass
Figure 4
Motor
Assembly
LED Assembly