Blue Clean 1900 PSI Instrucciones De Montaje, Cuidado Y Uso página 11

OPERATING INSTRUCTIONS OPERATING INSTRUCTIONS
Operation Tips
• If you hear the motor run intermittently when the
trigger is not being squeezed, that is normal.
The pump is priming itself so it is ready to operate
when the trigger is squeezed. Turn off the power
washer if not being used after five minutes.
• Keep the nozzle cleaning wire for use in unclogging
the nozzle. If you lose the cleaning wire, a
straightened paper clip also works.
How to Avoid Damaging Surfaces
• Damage to surfaces being cleaned occurs
because the impact force of the water pressure
exceeds the durability of the surface. Bare wood
can be penetrated; paint can be peeled off, etc.
You can vary the force of your power washer by
controlling:
1. The angle of the surface being cleaned
2. The distance of the nozzle from the surface
being cleaned
• NEVER use a narrow high pressure stream of
water on soft surfaces susceptible to damage.
• Use the 25˚ angle quick connect nozzle when
cleaning windows. Be sure to place the nozzle
approximately four to five feet away from the
window with the nozzle at forty five degree angle.
Squeeze the trigger and vary the spray pattern
and angle until optimum cleaning efficiency is
achieved.
Using Power Cord
• Easily remove the power cord from side of unit by
swiveling the bottom blue cord hook to the right or
left until it faces up. The power cord then can be
easily slid off of the side of the power washer unit.
• Swivel blue, cord hook back down when ready to
wrap the cord back into place for storage.
11