Nexgrill EVOLUTION INFRARED PLUS 720-0864M Guia Del Propietario página 22

Adjust High/Low Flame Setting Screw
1. Remove the grates and flame tamers.
2. Remove the two screws and the cotter clip that hold the
burner in place. Set aside the screw and pin.
3. Remove the burner from the grill by lifting the burner out.
4. Use a 6 mm socket and wrench or 6 mm nut driver to
remove the brass orifice from the end of gas valve.
Natural Gas Conversion Assembly Instructions
5. Replace with the Natural gas orifice.
IMPORTANT: Check that the orifice is properly installed
inside of the burner opening.
6. Reinsert the burner and reattach using the cotter pin
previously removed. Repeat the procedure for each
main burner.
7. Position the igniters so they are 1/8" (3.2 mm) away
from each burner.
22
continued