PREPARATION
Before beginning assembly of product, make sure all parts are present. Compare parts with package
contents list. If any part is missing or damaged, do not attempt to assemble the product.
Estimated Assembly Time: 10 minutes
No Tools Required for Assembly
ASSEMBLY INSTRUCTIONS
1. Place basin (D) on a flat, level surface. Attach the
female bird (A) and male bird (B) to the basin by
inserting the legs into the feet on the rim of the basin.
Twist the screw on the back of the feet to secure birds
in place.
2. Put pump (C) into basin (D). Route the power cord
out of the basin (D) through the square opening.
Connect the two tubes on the pump with the tubes
below the birds' feet. Make sure the tubes are
connected tightly.
3. Place LED light (F) into the holder on the center
bottom of the basin (D). Plug the end of the light power
cord into the end of the power cord from the pump (C).
Screw the preassembled ring over the cable to secure
the connection.
1
A
Screw
2
Water tube
3
4
Power cord
Opening
C
F
B
D