Flex FX2221 Manual Del Operador página 15

WARNING
making any assembly, adjustments or
changing accessories. Such preventive safety
measures reduce the risk of starting the tool
accidentally.
ADJUSTING THE BASE BEVEL ANGLE
The base can be tilted at 0° to 45° (left or right)
for bevel setting.
NOTICE: Remove the splinter guard if it is
inserted into the cover plate.
To set the bevel angle:
a. Remove the hex wrench from the base
(Fig. 17).
b. Turn the tool upside down and use the hex
wrench to loosen the hex screw by turning it
counterclockwise as shown (Fig. 18).
c. Push the base slightly backward and tilt it to
the desired angle (0° – 45°) using the scale
that is marked on the base bracket. Then
tighten the hex screw by turning it clockwise
(Fig. 19).
d. Return the hex wrench into its storage area
inside the base of the saw.
After adjusting the base, make a sample cut to
verify the bevel angle.
ADJUSTMENTS
Detach the battery pack
from the tool before
Fig. 17
Fig. 18
Fig. 19
-15-
Base Bracket