Bonnet Neve SKYSHINE Instrucciones De Uso página 17

OPEN DOOR LOCKING SYSTEM
For loading an cleaning purpose the door can be loked in open position by shifting the locking system as
shown by the arrow in the figure 16, page 7.
TENSION ADJUSTMENT OF DOOR CLOSING SPRING
If the tension of the return sprng has to be increased, it is necessary to carry out the steps in figure 17, page 7.
• Never leave upper glass sliders open or ajar (fig. 1). It is advisable to often check that all sliders are closed: you
will thus avoid unnecessary energy consumption and frost build-ups on the walls and you will also allow better foods
preservation.
CONTROLS
Down on the right, cabinets are fitted with a switch for the control of product lighting and with a remote thermo-
stat/thermometer for temperature control. The remote thermostat displays the temperature existing inside the case and
allows temperature control by the use of the appropriate keys.
WARNING: Adjustment is reserved for the technical personnel.
SHELVES: the shelves were designed to bear a maximum load of 160 kg/sq.m. for shelves
9. PRESCRIPTIONS AND RESTRICTIONS
Keeping pharmaceutical products in the display case is strictly forbidden (fig.10).
Do not remove protections or panels when it requires the use of tools. IN PARTICULAR, DO NOT REMOVE THE ELEC-
TRIC CONTROL BOARD COVER AND THE SCREWS FASTENING SHELF LIGHTING PLUGS.
Do not expose the display case to atmospheric agents (fig. 15). DO NOT STEP on the cabinet bumper rail. DO NOT
STEP on the top of the cabinet and DO NOT LAY WEIGHTS on it (fig. 11).
Caution: never remove the glass sliders. The cabinet was designed to only work with the sliders on.
Do not spill water directly or indirectly on the display case (fig. 13). Do not touch the equipment with damp or wet
hands or feet; do not use it while barefoot (fig. 14).
ANY OTHER USE NOT EXPRESSLY MENTIONED IN THIS BOOKLET MUST BE CONSIDERED AS HAZARDOUS.
THE MANUFACTURER ASSUMES NO RESPONSIBILITY FOR ANY DAMAGE RESULTING FROM IMPROPER,
INCORRECT OR UNREASONABLE USE.
10. ORDINARY MAINTENANCE
ATTENTION! BEFORE STARTING ANY MAINTENANCE OR CLEANING, DISCONNECT THE EQUIPMENT
FROM THE ELECTRICAL POWER SUPPLY USING THE MAIN WALL CUT-OFF SWITCH (fig. 19).
IMPORTANT: During maintenance or cleaning operations, be sure that the light in the working area is sufficient and
if necessary, use an additional source of light.
DOOR ANTIFOG LINER FILM
Cabinet doors are provided with an antifog liner film that prevents mist from building up in any temperature and humi-
dity condition, even after long immersion in water or frequent cleaning. Being extremely hydrophilic, this lining cau-
ses water drops to condense and disperse without turning into mist. However water absorbing, the antifog film does
15
UM000224