Product Operation; Cutting Guide - Marshalltown Bullet MARKSMAN ES00-1113 Manual De Usuario

When most materials are cut, the 'drop' piece will have a beveled edge, while the 'keep' piece (the piece left on
the table) will have a mostly square edge.
1. Slide the Camlock lever over to
unlock shear.
The safety lock can be disengaged by sliding the knob over.
Always re-engage the Safety Lock pin and secure the extended handle in the
down position while storing, carrying, or transporting your shear.
The Marksman is designed to cut a variety of materials. Some of the most common materials are Engineered
Hardwood Flooring (up to 1/2" / 12mm thick and 1250 Janka—ONLY cut by flipping material over with the back
facing up), laminate flooring, LVT/LVP/VCT, PVC, rubber tile, cover base, WPC/SPC/MLF, and rigid core.
Note: DO NOT attempt to cut any solid wood or high-pressure laminate. Additionally, do not cut
engineered hardwood with a Janka Hardness Rating higher than 1250, and do not cut engineered
hardwood with a Janka Hardness Rating lower than 1250 without first flipping over the material and
cutting with the back facing up.
Note: Even the approved materials may vary greatly in density and hardness. If extreme force is required to cut
a material stop immediately, as it could lead to damage to your shear or injury. Attempting to cut unapproved
materials will void the warranty.
WS2522revA
104 S. 8th Ave. Marshalltown, IA Phone 800-888-0127 / 641-753-0127 • Fax 800-477-6341 / 641-753-6341 www.MARSHALLTOWN.com

PRODUCT OPERATION

2. Place product on table. It is
recommended that you HOLD
MATERIAL IN PLACE until the
cut is complete. Bring handle
down until blade touches
material.
SAFETY LOCK
TRANSPORT

CUTTING GUIDE

3. Push handle down until the
material is cut completely.
Some effort may be required
depending of hardness of
material.
5 of 14