The Set Setting Menu - Sony VPL-FE100U Manual De Instrucciones

The SET SETTING Menu

The SET SETTING menu is used for changing the
initial settings of the projector. Unadjustable items are
not displayed in the menu.
SET SETTING
STATUS:AT ON
SPEAKER: ON
LANGUAGE: ENGLISH
INSTALLATION: FLOOR-FRONT
POWER SAVING: OFF
SIRCS RECEIVER: FRONT&REAR
GROUP INDEX: 0 1
DEVICE INDEX: 0 1
STATUS
Sets up the on-screen display.
ON: Shows all of the on-screen displays.
OFF: Turns off the on-screen displays except for the
menus and warning messages.
SPEAKER
Set to OFF to cut off the sound of the internal speaker
when external speakers are connected. When set to
OFF, "SPEAKER OFF" appears on the screen when
you turn on the power.
LANGUAGE
Selects the language used in the menu and on-screen
displays.
Available languages are: English, French, German,
Italian, Spanish, Japanese and Chinese.
INSTALLATION
Reverses the picture horizontally or vertically.
FLOOR-FRONT: The picture is not reversed.
CEILING-FRONT: The picture is reversed
horizontally and vertically.
FLOOR-REAR: The picture is reversed horizontally.
CEILING-REAR: The picture is reversed
vertically.
Note
In case of using a mirror, be careful of installation
since the picture may be reversed.
26
(GB)
INPUT-A
POWER SAVING
When set to ON, the projector goes into the power
saving mode and the lamp for light source turns off if
no signal is input for about 10 minutes.
The power saving mode is canceled when a signal is
input or any key is pressed.
SIRCS RECEIVER
Selects the remote control detectors to be activated.
Change the setting if the wireless Remote Commander
does not work properly due to the influence of the
fluorescent lamp, etc.
FRONT & REAR: Activates both the front and rear
detectors.
FRONT: Activates the front detector only.
REAR: Activates the rear detector only.
OFF: Activates neither the front nor rear detector.
Note
When set to OFF, the wireless Remote Commander
does not function. Use the keys on the control panel or
the wired Remote Commander.
GROUP INDEX
Groups multiple projectors or switchers to operate
them simultaneously.
You can set the group index number to the desired
number between 01 and 99.
For details for setting the group index, see pages 31 (GB)
and 32 (GB).
DEVICE INDEX
Displays the index number set with the INDEX
switches on the rear of the projector. You can check
the device index number but cannot set it with this
menu.
For details for setting the number, see page 31 (GB).