SEVERIN KS 9822 Instrucciones De Uso página 13

5. Take off the upper hinge by removing the 3 screws. Take
off the door and place it also on a soft, non-damaging
surface to protect it against scratching.
6. Remove the hinge cover B from the inside of the door and
install the hinge cover A provided into the hinge opening
on the other side of the door.
7. Remove both adjustable feet and the screws holding the
lower hinge and the foot mounting.
8. Remove the lower hinge. Unscrew the hinge pin and
reposition it in the other opening in the hinge. Now fi t
the lower hinge and the foot mounting on the respective
opposite sides. Fit the two adjustable feet. Place the door
onto the lower-hinge pin.
9. Take out the screws on the top left-hand side of the unit
and replace them on the top right. Turn the upper hinge
round through 180°. Unscrew the hinge pin and reposition
it in the other opening in the hinge. Unscrew the hinge pin
and reposition it in the other opening in the hinge. Fit the
hinge pin into the corresponding opening in the door and
tighten the screws to the secure the upper hinge to the
housing.
Replace the top cover and secure it by tightening the
holding screws. Finally, replace the screw covers.
10. Now change the position of the door handle:
Take off the screw covers, remove the screws and then
take off the handle.
Remove the blind covers on the other side of the door and
reposition the handle in the new location.
Replace the blind covers on the other side.
11. Put the unit back in its intended position and wait for about
two hours before connecting it to the mains.
13