Troubleshooting - SEVERIN KS 9822 Instrucciones De Uso

Trouble-shooting
Certain typical sounds can be heard when the appliance is
switched on. These sounds are:
∙ caused by the electric
motor within the
compressor assembly;
during compressor
start-up the sound
level will be slightly
higher for a limited
period of time.
∙ caused by the cooling agent fl owing through the circuit.
Problem
The appliance is not working.
The normal operating sound changes or
becomes louder.
Water is collecting on the bottom of the unit.
Transporting the unit
To prevent damage to the unit during transport, ensure that all
accessories and components inside and around the appliance
are securely fastened.
The unit must only be transported in its vertical position; do not
tilt any more than 30°.
Once the unit has been positioned, wait for about 30 minutes
before it is connected to the mains.
If the unit has been tilted more than 30° during transport, allow
it to stand in an upright position for at least 4 hours before it is
connected to the mains.
Disposal
This appliance has been manufactured from
recyclable materials. After removing the plug from the
wall socket, the unit should be rendered unusable
by cutting off the power cord before being disposed
of through special waste collection points in accordance with
local regulations. The refrigerant and the chemical agent in
the insulation foam must be disposed of through a competent
agency. Take special care not to damage the cooling circuit
before the unit is handed over for competent disposal.
The following table lists the possible malfunctions, their
probable causes and solutions. In the event of operational
problems, check fi rst whether a solution can be found using this
table. If the problem persists, disconnect the appliance from the
mains power and c ontact our Customer Service Department.
Possible cause and solution
∙ There is a power failure
∙ The main fuse has blown.
∙ The temperature control is set to '0'.
∙ The fuse in the wall socket (if applicable) has blown. This can be checked by
connecting another electrical device to the socket and checking for function.
∙ Check for proper positioning (uneven fl oor?).
∙ Are any adjacent objects affected by the running of the cooling unit (i.e.
caused to vibrate?)
∙ Are there any objects on top of the unit which might be vibrating?
The melt-water drain system is blocked. Remove the blockage and clean the
system.
Guarantee
This product is guaranteed against defects in materials
and workmanship for a period of two years from the date of
purchase. Under this guarantee the manufacturer undertakes
to repair or replace any parts found to be defective, providing
the product is returned to one of our authorised service centres.
This guarantee is only valid if the appliance has been used in
accordance with the instructions, and provided that it has not
been modifi ed, repaired or interfered with by any unauthorised
person, or damaged through misuse.
This guarantee naturally does not cover wear and tear, nor
breakables such as glass and ceramic items, bulbs etc. This
guarantee does not affect your statutory rights, nor any legal
rights you may have as a consumer under applicable national
legislation governing the purchase of goods. If the product fails
to operate and needs to be returned, pack it carefully, enclosing
your name and address and the reason for return. If within the
guarantee period, please also provide the guarantee card and
proof of purchase.
15