gala gar GALA MIG 2300 ALU 4R Manual Técnico De Instrucciones página 12

1.1. ACCESSORIES.
A series of accessories are required to correctly install the equipment and use it appropriately. These must
be chosen in agreement with the table below.
Earth cable.
Wire drive rollers.
Protection hand screen.
Recommended torch.
Recommended pressure reducing valve.
Gas economiser system.
FOR THE USE OF ANY OTHER ACCESSORY CONSULT THE MANUFACTURER.
GALA MIG (V. COMPACTA). Manuel d'Instructions
Accessories included in the GALA MIG series equipment.
GALA MIG 1810 GALA MIG 2300 ALU 4R
2
L=4 m. S=25 mm Ref. 437.12.219 (X)
0.8-1.0 mm ∅30-"V"
0.8-1.0 mm ∅40-"V"
Ref. 49416022 1.0-12 mm ∅30-"U"
MINIMUM PROTECTION TONE 11. (HAND SCREEN Ref. 675.00.03)
Recommended accessories.
GALA MIG 1810
MX-15 ; 150 A/60%
MX-25 ; 200 A/60%
315 Kg./cm
Reference
215.00.004
225.00.004
236.00.004
INTAKE PRESSURE (bar)
OUTLET PRESSURE (bar)
NORMAL FLOW Q
MAXIMUM FLOW Q
The Econogala economiser valve is capable of saving up to 50% of the
consumption of any welding shielding gas, use in MIG-MAG-TIG procedures.
In case of spot welding it is possible to be obtained up to a 50% of saving, in
the welds of long joints the saving can be around 20%.
It is easy and simple to install, not needing any type of special coupling. It
must be next to a pressure reducing valve with single expansion chamber.
GALA MIG 2600
L= 4 m; S= 35 mm
Ref. 438.12.219
Ref. 49216022 0.8-1.0 mm ∅40-"V"
Ref. 49416022
Ref. 62006021
GALA MIG 2300 ALU 4R
MX-25 ; 200 A/60%
2 28 L/min. (MOD. EN-2 Ar-CO
ARGON-MIX (ECNONOGALA MOD. Ref. 355.00.000)
Maxima Torch
Welding intensity
Model
100 % 60 %
MX-15 115
MX-25 155
MX-36 235
EN-2 Ar-CO2 Ref: 376.00.000
1
maz
ECONOGALA REF: 355.00.000
GALA MIG 2600
2 L= 4 m; S= 35 mm
Ref. 438.12.219
0.8-1.0 mm ∅40-"V"
Ref. 49416022
GALA MIG 2600
MX-25; 200 A/60%
MX-36; 300 A/60%
MX-36; 300 A/60%
- Ref. 376.00.000)
2
Wire Ø
(Recommended)
35%
150 195 0.6 - 0,8 mm
200 260 0,8 - 1 mm
300 395 1 - 1,2 mm.
200
10
20 Nl/ min
28 Nl/ min
12
2
GALA MIG 4000