Idiomas disponibles
Idiomas disponibles
en
18
Changing the tool (ABSS18-1.6E (**)).
Before mounting or replacing application tools or accessories, remove the bat-
WARNING
tery. This preventive safety measure rules out the danger of injuries through
accidental starting of the power tool.
Cutter blades and cutting bars cannot be reground.
Replacing cutter blades (figure 8).
Press the engaged supporting pin out in lateral
direction until the cutter blade can be
removed.
Pull the cutter blade out of the cutter head.
Lightly grease the supporting pin and the new
cutter blade.
Insert the new cutter blade. Slide the support-
ing pin through the hole of the cutter blade
until it engages.
Turning or replacing cutting bars
(figure 9).
Loosen the screws with the hex key.
When the front half of the cutting edges on
the cutting bars are dull, turn the cutting bars
by 180° and mount them each to the opposite
side.
When both cutting edge halves are dull,
replace the cutting bars.
Fig.8
4.
3.
2.
5.
Supporting pin
Fig.9
2,5 mm
Cutting bars
4.
3.
4.
3.
Cutter blade
4.
1.
6.
4.
2.
1.
Screws
2.
1.
5.
5.
