cecotec HidroBoost 1400 EasyMove Manual De Instrucciones página 22

ENGLISH
NOTE: Pay special attention when cleaning delicate surfaces such as bodywork o wheel rims,
lacquered surfaces, wood, paint, etc.
SPRAY MODE
Turn the pulverizing nozzle to select the flat-fan pattern. A
wide stream will distribute the impact of water over a larger
area, resulting in excellent cleaning action with a reduced
risk of surface damage. Large surface areas can be cleaned
more quickly using a wider stream.
TURBO MODE
Use the 3D TurboFlip nozzle to clean with turbo mode. Water
is distributed in a spiral-shaped stream. The 3D TurboFlip
nozzle combines the power of a focused high-impact
stream and the efficiency of a 25-degree stream. This turns
the narrow high-impact stream into a cone-shaped one that
cleans thoroughly larger areas.
PRODUCT OPERATION
NOTE: The motor on this pressure washer does not run continuously. It only runs when the
trigger of the spray gun is squeezed. After following the start-up procedures in this manual,
turn the pressure washer on and squeeze the trigger for activation.
NOZZLE CLEANING
A clogged or partially clogged nozzle can cause a significant reduction of water coming out of
the nozzle and cause the unit to pulsate while spraying. To clean out the nozzle:
• Turn off and unplug the unit.
• Turn off water supply. Relieve any pressure trapped in the high-pressure by squeezing
the trigger 2-3 times.
• Separate the lance from the gun.
• Rotate the nozzle to the narrow stream setting. This activates the fan blades.
• Use the cleaning kit provided, or any other type of pointed element such as an unfolded
paper clip to clean the nozzle. Insert the wire into the nozzle hole and move back and
forth until debris is dislodged. (See Figure 2).
22 HIDROBOOST 1400 EASYMOVE
Fig. 2