Tabla de contenido
Idiomas disponibles
Idiomas disponibles
8. Pump handle to lift until saddle contacts load.
Continue to pump the jack handle to lift the
vehicle to the desired height. After lifting, support
the load with appropriately rated vehicle support
stands before working on the vehicle.
CAUTION: NEVER WIRE, CLAMP OR
OTHERWISE DISABLE THE LIFT CONTROL
VALVE TO FUCTION BY ANY MEANS
OTHER THAN BY USING THE OPERATOR'S
HAND. USE THE HANDLE PROVIDED WITH
THIS PRODUCT OR AN AUTHORIZED
REPLACEMENGT HANDLE TO ENSURE
PROPER RELEASE VAVLE OPERATION. DO
NOT USE EXTENSIONS ON THE AIR HOSE
OR ON THE OPERATING HANDLE.
LOWERING THE JACK
1. Raise load high enough to allow clearance for the
jack stands to be removed, then carefully remove
jack stands.
2. Remove support stands.
3. Grasp the handle firmly with both hands. Securely
hold on to the jack handle so your hands do not
slip and ensure the release valve does not rapidly
lower.
4. Carefully open the Release Valve by slowly
turning the handle counterclockwise. (Do not
allow bystanders around the jack or under the
load when lowering the jack.
5. After removing jack from under the load, push ram
and handle sleeve down to reduce exposure to
rust and contamination.
WARNING: WARNING USE EXTREME
CAUTION WHEN LOWERING THE JACK.
THE JACK HANDLE MAY TURN RAPIDLY.
OPENING THE RELEASE VALVE TO FAST
CAN CAUSE THE JACK TO LOWER RAPIDLY.
FAILURE TO HEAD THESE WARNINGS
COULD CAUSE SERIOUS INJURY OR DEATH.
8
Tabla de contenido
