Turn The Rear Handle; Maintenance; Clean The Machine; Lubricate The Blade - GreenWorks HTF313 Manual Del Operador

EN
8.3

TURN THE REAR HANDLE

You can use the rotating button to adjust the rear handle to 5
different positions to cut the hedges easier.
1. Put the machine on a flat and smooth surface.
2. Pull the rotating button and turn the rear handle.
3. Release the rotating button until it locks into position.
9

MAINTENANCE

Do not let brake fluids, gasoline, petroleum-based materials
touch the plastic parts. Chemicals can cause damage to the
plastic, and make the plastic unserviceable.
Do not use strong solvents or detergents on the plastic
housing or components.
Remove the battery pack from the machine before
maintenance.
9.1

CLEAN THE MACHINE

Keep the machine and the motor free of leaves, branches or
excessive oil to prevent fire risks.
• Use a moist cloth with a mild detergent to clean the
machine.
• Clean all moisture with a soft dry cloth.
• Use a small brush to clean the air vents.
9.2

LUBRICATE THE BLADE

To increase the efficiency and life of the blades, lubricate
them carefully after each work session:
CAUTION
CAUTION
WARNING
WARNING
English
• Put the machine on a flat and smooth surface.
• Use a soft cloth to clean the blades and a brush to remove
more dirt.
• Use a light layer of oil to lubricate the blades along the
top edge of the blade.
We recommend to use the non-pollutant type oil.
10

STORE THE MACHINE

Clean the machine before storage.
1. Remove the battery pack.
2. Let the motor cool.
3. Check that there are no loose or damaged components. If
it is necessary, replace the damaged components, tighten
screws and bolts, or speak to a person of an approved
service center.
4. Store the machine in a cool and dry location.
11

TROUBLESHOOTING

Problem
The motor does
not start when you
pull the trigger.
The machine
smokes during op-
eration.
The motor is on,
blades do not
move.
8
NOTE
NOTE
Possible cause Solution
Make sure that
The battery pack is
you tighlty install
not installed tight-
the battery pack in
ly.
the machine.
The battery pack is Charge the battery
out of power. pack.
1. Immediately
stop the ma-
chine.
The machine has
2. Remove the
damage.
battery pack.
3. Speak to serv-
ice center.
Do not use the ma-
The machine has
chine and speak to
damage.
service center.
Remove battery
The blades are pack then clear
blocked. blockage from the
blades.