Description; Purpose; Overview; Safety - GreenWorks PTC305 Manual Del Operario

EN
1

DESCRIPTION

1.1

PURPOSE

This machine is intended for cutting and trimming hedges and
bushes in domestic use.
1.2

OVERVIEW

Figure 1
1 Blade
2 Pivoting head
3 Pivoting button
4 Coupler
5 Safety lock button
2

SAFETY

Make sure that you do/obey all safety instructions.
Refer to Safety Manual.
3

UNPACK THE MACHINE

Make sure that you correctly assemble the machine before
use.
• If the parts are damaged, do not use the machine.
• If you do not have all the parts, do not operate the
machine.
• If the parts are damaged or missing, speak to the service
center.
1. Open the package.
2. Read the documentation in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
5. Discard the box and package in compliance with local
regulations.
3.1

FIT THE PIVOTING HEAD

Figure 2
1. Align the handle with the trimmer head.
2. Push the trimmer head onto the handle.
3. Fasten the coupler.
Periodically check the connections to ensure that they are
tightened securely.
6 Trigger
7 Rear handle
8 Battery release button
9 Auxiliary Handle
WARNING
WARNING
WARNING
WARNING
English
3.2

REMOVE THE PIVOTING HEAD

Figure 3
1. Rest the machine on the ground.
2. Loosen the coupler.
3. Take off the poviting head.
3.3 ATTACH THE AUXILIARY
HANDLE
Figure 4.
1. Loosen the screws in the handle with a screwdriver (not
included) and remove the screws from the handle.
2. Attach the auxiliary handle and clamp on the shaft.
3. If necessary, adjust handle up or down to desired
operating position.
4. Insert and tighten the screws so that the handle cannot be
rotated on the shaft.
3.4

INSTALL THE BATTERY PACK

Figure 5
• If the battery pack or charger is damaged, replace the
battery pack or the charger.
• Stop the machine and wait until the motor stops before
you install or remove the battery pack.
• Read, know, and do the instructions in the battery and
charger manual.
1. Align the lift ribs on the battery pack with the grooves in
the battery compartment.
2. Push the battery pack into the battery compartment until
the battery pack locks into place.
3. When you hear a click, the battery pack is installed.
3.5

REMOVE THE BATTERY PACK

Figure 5
1. Push and hold the battery release button.
2. Remove the battery pack from the machine.
4

OPERATION

• Do not put your fingers into the notches or in position
where they can get cut.
• Do not touch the blade unless you remove the battery
pack.
• Do not use the machine if the blade is damaged or bent.
• Remove all objects such as cords, lights, wire, or string
which can become entangled in the cutting blade and
create a risk of personal injury.
4
WARNING