Important Safety Instructions - Black+Decker LSW20 Manual De Instrucciones

Balai sans fil avec bloc-piles au lithium, 20 v max
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

ImpORtAnt sAFEty InstRuCtIOns

fOR BATTERY CHARGERS
This manual contains important safety instructions for battery chargers.
• Before using charger, read all instructions and cautionary markings
on charger, battery pack, and product using battery pack.
wARnInG:
to get inside charger.
wARnInG:
injury, charge only designated Black+Decker batteries. Other types
of batteries may burst causing personal injury and damage.
CAutIOn:
charger plugged in to the power supply, the charger can be shorted
by foreign material. Foreign materials of a conductive nature such
as, but not limited to, steel wool, aluminum foil, or any buildup of
metallic particles should be kept away from charger cavities. Always
unplug the charger from the power supply when there is no battery
pack in the cavity. Unplug charger before attempting to clean.
wARnInG:
• the charger supplied with this product is intended to be
plugged in such that it is correctly orientated in a vertical or
floor mount position.
• DO nOt attempt to charge the battery pack with any chargers
other than the ones in this manual. The charger and battery
pack are specifically designed to work together.
• these chargers are not intended for any uses other than
charging designated Black+Decker rechargeable batteries.
Any other uses may result in risk of fire, electric shock or electrocution.
• An extension cord must have adequate wire size (AWG
or American wire Gauge) for safety. The smaller the gauge
number of the wire, the greater the capacity of the cable, that is 16
gauge has more capacity than 18 gauge. When using more than
one extension to make up the total length, be sure each individual
extension contains at least the minimum wire size.
shock hazard. Do not allow any liquid
Burn hazard. To reduce the risk of
Under certain conditions, with the
Recommended minimum wire size for Extension Cords
minimum Gauge for Cord sets
volts
120V
0-25
240V
0-50
Ampere Rating
More Not more
Than Than
0
-
6
18
6
-
10
18
10 -
12
16
12 -
16
14
• Do not expose charger to rain or snow.
• pull by plug rather than cord when disconnecting charger.
This will reduce risk of damage to electric plug and cord.
• make sure that cord is located so that it will not be stepped
on, tripped over, or otherwise subjected to damage or stress.
• Do not use an extension cord unless it is absolutely
necessary. Use of improper extension cord could result in risk of
fire, electric shock, or electrocution.
• Do not place any object on top of charger or place the
charger on a soft surface that might block the ventilation
slots and result in excessive internal heat. Place the charger
in a position away from any heat source. The charger is
ventilated through slots in the top and the bottom of the housing.
• Do not mount charger on wall or permanently affix charger
to any surface. The charger is intended to use on a flat, stable
surface (i.e., table top, bench top).
• Do not operate charger with damaged cord or plug — have
them replaced immediately.
• Do not operate charger if it has received a sharp blow, been
dropped, or otherwise damaged in any way. Take it to an
authorized service center.
• Do not disassemble charger; take it to an authorized service
center when service or repair is required. Incorrect reassembly
may result in a risk of electric shock, electrocution or fire.
4
total Length of Cord in Feet
26-50
51-100 101-150
51-100 101-200 201-300
American Wire Gauge
16
16
14
16
14
12
16
14
12
12
Not Recommended
Tabla de contenido
loading

Tabla de contenido