Tool Settings - jbc CV-E Manual De Instrucciones

Parameters
Be careful when using these parameters as they may reduce the tip life if not used properly. Please
follow the recommended guidelines:
Station Settings
Recommendations
Parameter description
Temperature unit N/a
Celsius (ºC) or Fahrenheit (ºF)
Maximum temperature
Set the maximum
temperature to work with.
Max. temp by default is 400°C
(750°F). This is considered
high enough to work with The station temperature
most lead-free applications. range is 180-450ºC
(356-840ºF). Change the
temperature limits when
working with less common
Minimum temperature applications such as low /
Set the minimum high melting point solde-
temperature to work with. ring (HMP) or plastics (e. g.
Min. temp. by default is riveting).
200ºC (392ºF). This is consi-
dered to be a proper starting
point for leaded applications.
Metronome Useful for setting a work rate
This activates a beep sound. in repetitive jobs. The beep
Frequencies vary from 1 to 50 lets you know the length of
seconds. time the tip must be in con-
tact with the soldering joint.
Help text N/a
Activate this parameter to
receive info from the system.
Beep N/a
enable/disable the beep
sound of the keypad.
Change pin The PIN must be entered
Change the default security every time a parameter is
PIN number (0105). changed.
12
Warnings
In most cases,
working with temperatures
over 400°C (750°F) can
damage the PCB and its
components. even in short
time periods of tip contact
with the soldering joint, the
flux may not work properly
and could seriously reduce
tip life.
If the solder joint requires
more power (e.g. multila-
yered or high dissipation
boards), JBC strongly
recommends using other
aids like preheaters.
N/a
N/a
N/a
N/a

Tool Settings

Parameter description
Recommendations
Fix one temperature Ideal for soldering more than
Fix a value within the one component at a specific
temperature range of the sta- temperature. The station will
tion (180-450ºC/356-840ºF). reject any attempt to change
the temperature.
This allows a quick change
Temperature levels set
Similar to "Fix one temp" between 3 different tempe-
parameter. In this case, the ratures. Set them according
user can set up to 3 values for to the allowed values for your
different power requirements. soldering applications.
Sleep delay Because our tools reach the
Set the time that the tool will working temperature from the
remain at the selected tempe- deafult Sleep mode in only a
rature when in the stand be- few seconds, this parameter
fore entering sleep mode. The is preset to 0 min. Once the
tip temperature will then drop tool is returned to the stand
to the Sleep temperature. the temperature will automati-
cally drop to the sleep tempe-
rature, extending tip life and
avoiding oxidation. Retinning
the tip before placing the tool
in the stand will protect the tip
and extend its life.
Sleep temperature The sleep temperatures
This is the set temperature the are set to achieve a ba-
tip reaches when returned to lance between preventing
the stand. oxidation and reaching the
working temperature in a few
seconds.
w w w.jbctools.com
Warnings
N/a
N/a
Setting these
parameters to higher
values will unnecessarily
accelerate oxidation
and shorten tip life
especially when working
with temperatures up to
450°C (840°F).
13