Stihl MSE 250 C Manual De Instrucciones página 7

To reduce the risk of
injury to your eyes never
operate your power tool
unless wearing goggles
or properly fitted protec -
tive glasses with
adequate top and side
protection complying with
ANSI Z87 "+" (or your
applicable national stand -
ard). If there is a risk of
injury to your face, STIHL
recommends that you
also wear a face shield or
face screen over your
goggles or protective
glasses.
Wear an approved safety
hard hat to reduce the
risk of injury to your head.
Chain saw noise may
damage your hearing.
Wear sound barriers (ear
plugs or ear mufflers) to
help protect your hearing.
Continual and regular
users should have their
hearing checked
regularly.
Be particularly alert and cautious when
wearing hearing protection because
your ability to hear warnings (shouts,
alarms, etc.) is restricted.
THE CHAIN SAW
For illustrations and definitions of the
chain saw parts see the chapter on
"Main Parts."
MSE 250 C
WARNING
Never modify this chain saw in any way.
Only attachments supplied by STIHL or
expressly approved by STIHL for use
with the specific STIHL model are
authorized. Although certain
unauthorized attachments are useable
with STIHL chain saws, their use may, in
fact, be extremely dangerous.
WARNING
Never operate your chain saw if it is
damaged, improperly adjusted or
maintained, or not completely or
securely assembled.
If this chain saw is subjected to
unusually high loads for which it was not
designed (e.g. heavy impact or a fall),
always check that it is in good condition
before continuing work. Check in
particular that the controls and safety
devices are working properly. Do not
continue operating this machine if it is
damaged. In case of doubt, have it
checked by your STIHL servicing dealer.
THE USE OF THE CHAIN SAW
Transporting the Chain Saw
WARNING
Always switch off the motor, move front
hand guard to ƒ before putting the
chain saw down. Carrying a chain saw
with the motor running may be extremely
dangerous.
Accidental acceleration of the motor can
cause the saw chain to rotate. Always
engage the chain brake by moving the
front hand guard to ƒ when taking more
than a few steps.
By hand: When transporting your chain
saw by hand, the motor must be
switched off and the chain saw must be
in the proper position, i.e., grip the top
handle; the chain guard (scabbard)
should be over the chain and guide bar,
which should point backwards, away
from the direction in which you are
walking.
WARNING
Do not carry the chain saw by the power
cable. Carry the cable in your hand. If
the cable is dragged on a rough surface
(concrete etc.) the cable may become
damaged.
English
5