Kenmore 146.34611410 Manual De Uso página 24

Side burner
□ Loosen side burner in side shelf. (B ). To loosen, unscrew and remove two front screws and washers
□ Remove the 2 pre-installed screws from the valve stem and set them aside. (C)
□ Insert valve stem through hole in fascia. (D). Install previously removed 2 screws .Note:Do not tighten
□ Attach bezel to facial and valve face with the installed screws .Firstly attach one side key hole of
□ Place sideburner tube over the valve, making sure that valve is inside sideburner tube. (H)
□ Push control knob onto sideburner valve stem. (I)
□ Reattach sideburner to sideburner shelf with the 2 previously removed screws. Replace sideburner
□ Connect both igniter wires to the igniter module on the inside of the right fascia. To connect, push
□ Unscrew igniter cap from control panel. Insert (1) AAA battery (provided in blister pack) into battery
A
A
C
C
E
G
24 •34611-40100219
holding sideburner in place. (A). Note: Do not loosen electrode screw.
these 2 screws until the bezel is attached to fascia and valve face.(E).
bezel to the screw ,then attach the other one to the other screw.Make sure the black mark facing
up.(F). Tighten the 2 screws .(G)
grate. (J)
igniter wire tips onto pins in igniter module.(K)
slot with positive end (+) facing outward. Screw igniter cap back onto panel. (L)
E
B
B
D
D
F
F
H