Plumbing Installation - Heatworks 1X Manual Del Usuario

6

PLUMBING INSTALLATION

Follow all plumbing instructions carefully. This product
MUST be installed by a licensed plumber in accordance
with all applicable national, state, provincial, and local
plumbing codes.
STEPS
1) Flush the existing water lines to eliminate all plumbing
or plastic paste or residue caused by any previous
brazing or soldering.
2) Turn off the main water supply.
3) Connect the hot water line to the MODEL 1X outlet
marked "outlet" located on the top of the unit.
HEATWORKS RECOMMENDS:
hoses and push-fit fittings for ease of installation.
OULET / TOP
1
BEFORE PUSH-FIT
PUSH-FIT FITTING FITTING
CAUTION: Breaker must remain off until installation is complete.
8
Use flexible water heater
2 3
INSTALLED
PUSH-FIT FITTING
4) Connect the outlet from tank heater supply to inlet of
MODEL 1X on the bottom of the unit.
HEATWORKS RECOMMENDS: Install a manual shut-off
valve (ball valve) on the inlet side of the Heatworks
MODEL 1X to provide a convenient shut-off point.
INLET/BOTTOM
1
BEFORE PUSH-FIT
PUSH-FIT FITTING FITTING
5) Turn on the main water supply.
6) Purge all air from the water lines and MODEL 1X by
opening a hot water demand source (hot faucet, shower,
etc.). Allow water to run though the water heater for at
least 2 to 3 minutes. Run water until there is a steady
water stream without any air.
2 3
INSTALLED
PUSH-FIT FITTING
www.myheatworks.com