DeWalt DHS790 Manual De Instrucciones página 10

FIG. 4
Q
P
O
N
E
M
E
Your saw is capable of cutting baseboard moldings held vertically 0.8" (20 mm) thick by 6.75"
(171 mm) tall on a 45º right or left miter, when using the slide lock lever (AN, Fig. 10).
NOTE: Your saw is capable of cutting the following once a special setup procedure is
followed. Refer to Special Cuts.
0° miter Height 1.5" (38 mm)
45º miter Height 1.5" (38 mm)
Familiarization
Your miter saw is fully assembled in the carton. Open the box
and lift the saw out by the convenient lifting handle, as shown
in Figure 5. Place the saw on a smooth, flat surface such as a
workbench, strong table or D WALT miter saw stand. Examine
e
Figure 4 to become familiar with the saw and its various parts.
The section on adjustments will refer to these terms and you
must know what and where the parts are.
CAUTION: Pinch Hazard. To reduce the risk of injury, keep
thumb underneath the operating handle (A) when pulling the
handle down. The lower guard will move up as the handle is
D
K L J I H G F
Width 16.1" (409 mm)
Width 11.7" (297 mm)
FIG. 5
E
pulled down which could cause pinching. The handle is placed close to the guard for special
cuts.
Press down lightly on the operating handle and pull out the lock down pin (Q, Fig. 4). Gently
release the downward pressure and hold the arm allowing it to rise to its full height. Use the lock
down pin when carrying the saw from one place to another. Always use the carrying handle to
transport the saw or the hand indentations (M, Fig. 4).
COMPONENTS (Fig. 4)
WARNING: Never modify the power tool or any part of it. Damage or personal injury could
result.
A. Operating handle K. Miter scale
B. Trigger switch L. Miter scale screws
C. Trigger lock-off button M. Hand indentations
D. Lower guard N. Fence
E. Mounting holes O. Bevel scale
F. Miter lock lever P. Bevel scale pointer
G. Miter release button Q. Lock down pin
H. Miter detent override lever R. Lifting handle
I. Kerf plate S. CUTLINE™ worklight
switch
J. Miter scale pointer
8
A
B
C
S
R
AA
Z Y
T. Battery packs
U. Rails
V. Rail lock knob
W. Rail adjustment screw
X. Dust port
Y. Hex wrench
Z. Bevel lock knob
AA. Clamp hole
T
V
W
U
X