Assembly And Operation - Worx SWITCHDRIVER WX176L Manual De Instrucciones

OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the instruction book carefully.
INTENDED USE
The machine is intended for drilling (including pilot hole) in wood, metal and plastic as well as
for driving and removing fasteners.

ASSEMBLY AND OPERATION

ACTION
BEFORE OPERATION
Removing the Battery Pack
Charging the Battery Pack
More details can be found in charger's manual
Installing the Battery Pack
ASSEMBLY
Inserting the Bits
Removing the Bits
OPERATION
Rotating the Dual Chuck
Forward/reverse Rotation Control
WARNING: Never change the direction of rotation when the chuck is
rotating, wait until it has stopped!
Two-speed Gear Control
WARNING: To prevent gear damage, always allow the chuck to come to a
complete stop before changing gears.
Drilling/driving Torque Setting
On/off Switch
WARNING: Do not operate for long periods at low speed because
excess heat will be produced internally.
Using the LED light
WARNING: To turn on the light, press the On/Off Switch and make sure
the Forward/Reverse Rotation Control is on right/left position.
The LED Light is also a battery capacity indicator. It will flash when power gets
low.
Cordless Drill / Driver
FIGURE
See Fig. A1
See Fig. A2
See Fig. A3
See Fig. B
11
See Fig. C
See Fig. D
See Fig. E1,
E2, E3
See Fig. F
See Fig. G
See Fig. H
See Fig. H
EN