Bosch HEI80 Instrucciones De Instalación página 12

Install Strain Relief
Place strain relief in knockout below terminal block.
9 WARNING
The strain relief provided with your range cord must
be properly installed.Strain reliefs vary. Carefully
read and follow the instructions included with your
strain relief.
1. In the knockout panel below the terminal block, remove
the knockout that fits our strain relief.
2. Feed range cord through hole and strain relief up to
terminal block. Allow for slack in the cord between the
strain relief and terminal block.
3. Once cord length/slack has been adjusted, attach
strain relief per instructions included with strain relief.
Tip: The knockout panel (below the terminal block) can be
removed from the range to install the strain relief: Remove
panel from range, install strain relief in panel and reattach.
DO NOT remove entire range back panel.
9 WARNING
Risk of Electric Shock or Fire. Frame grounded to
neutral through a ground strap. Grounding through
the neutral conductor is prohibited for new branch-
circuit installations (1996 NEC), mobile homes, and
recreational vehicles, or in an area where local
codes prohibit grounding through the neutral
conductor.
For installations where grounding through the neu-tral
conductor is prohibited, (a) disconnect the link from the
neutral, (b) use grounding terminal or lead to ground unit,
(c) connect neutral terminal to lead branch circuit neutral in
usual manner (when the appliance is to be connected by
means of a cord kit, use 4-conductor cord for this purpose.
Use only cord kits rated 125/250 volts (minimum), 30
amperes and labeled "For Use with Ranges". Strain relief
provided with cord must be installed per instructions
included with cord.
English 9
3-Wire Hookup
R=Red
W = White
GS = Grounding Strip
B = Black
.
9 WARNING
To prevent electrical shock, the grounding prong on
the range cord should not be cut or removed under
any circumstances. It must be plugged into a
matching grounding type receptacle and connected
to a correctly polarized 240- Volt circuit. If there is
any doubt as to whether the wall receptacle is
properly grounded, have it checked by a qualified
electrician.
Four wire range cord connection (Recommended
Method)
1. Disconnect electrical power at breaker box. Remove
the terminal block cover to expose the terminal block.
2. Remove the top nut (has an attached locking washer)
from each post.
Note: DO NOT remove the second nut/washer on each
post. These must stay in place to anchor the internal
wiring attached to the terminal block.
3. Remove screw from bottom end of ground strap.
4. Remove the green grouning screw from the lower end
of the grounding strap. Remove the upper end of the
grounding strap from the center post of the junction
bar. Rotate the grounding strip (A) so that the wide end
4-Wire Hookup
R=Red
W = White
G = Green
B = Black