8 - ENGLISH
Needle Position Setting
a. At any time when the motor is on but not running, press the
up button "▲".
If the LED indicates: "P.u" it means the needle position setting
is POSITION UP when the sewing machine is stopped.
If the LED indicates: "P.d" It means the needle position setting
is POSITION DOWN when the sewing machine is stopped.
This is the default factory setting.
b. Press "▼/ ▲" to switch the setting of the needle position
between either UP or DOWN.
When positioner sensor is set correctly to the UP position and you stop sewing, the needle will stop
at the UP position. If you then heel the treadle, the motor will rotate to put the needle in the DOWN
position.
When the position sensor is set to the DOWN position and you stop sewing, the needle will stop at the
DOWN position. If you then heel the treadle, the motor will rotate to put the needle in the UP position.
Error Messages and Trouble Shooting
When an error message appears on the display the motor will stop automatically to protect the electronics
of the motor and most importantly, to protect the motor circuit board.
If an error message occurs be sure to repeat the action that caused the error message. Many times if
you reactivate the treadle and start the motor again, the error message will clear indicating this was a
False error message requiring no further action.
There are two types of error messages:
1) False error messages
2) True error messages if the error is repeated.
False errors messages are common in areas where the electricity being supplied is unstable due
to fluctuations, interference and spikes in electrical power supply to the motor. If these False error
messages happen quite often it is recommended to contact a local electrician to see if the power
supplied to the motor can be filtered. Doing so will eliminate False error messages.
True error messages do occur occasionally indicating a problem with an electrical component, the
motor circuit board and on a very rare occasion, a faulty motor.
A complete and current listing of error messages and trouble shooting can be found at www.endurosaves.com.
www.endurosaves.com
alternate "ready" status
Either "P.d" or "P.u" will indicate
"ready status, depending on how
the needle position is set.
default "ready" status
