Velleman DTO6234N Manual Del Usuario página 6

5. Battery
1. The battery symbol is displayed when the batteries need to be
replaced (battery voltage < ± 5 V). Open the battery
compartment and remove the old batteries.
2. Insert 1 x 9 V battery. Faulty installation can permanently
damage the device.
3. Remove the batteries if the device is not to be used for some
time.
6. Operation
Attach a small strip of tape to the target surface. Press the MEAS to
switch on the tachometer. Select whether to measure the RPMs
(RPM) or the revolutions (REV) with the MODE button. Point the
tachometer at the strip of tape and hold the MEAS button pressed.
The indicator should appear on the display when you point the
beam at the strip of tape.
7. Memory Button (MEM)
The last measured RPM value is automatically stored in the memory.
Refer to the illustration on page 3 of this manual.
V. 02 – 25/10/2016
DTO6234N
WARNING
Do not puncture batteries or throw
them in fire as they may explode. Do
not attempt to recharge non-
rechargeable batteries (alkaline).
Dispose of batteries in accordance with
local regulations. Keep batteries away
from children.
WARNING
Remove the batteries if you are no
longer using the device or if the device
is left unused for an extended period of
Remove used batteries promptly.
time.
6 ©Velleman nv